Hi everyone,
Just started using Resolume and its super cool. Having trouble figuring out how to do something though.
I have 3 components in my current setup running:
- SoundSwitch (a program sending DMX over Artnet to Resolume)
- Resolume (receiving DMX Input via Artnet from SoundSwitch and outputting DMX via Artnet)
- An LED tape fixture connected to an Arduino receiving DMX via Artnet
I have confirmed that SoundSwitch is sending DMX to Resolume and that Resolume can send DMX to my Arduino, and hence control my fixture via the advanced output section.
However what I cannot figure out it how to pass the DMX input part of Resolume as the DMX output to my fixture.
Essentially I want Resolume to act as a pass through for this information here.
I tried to connect Soundswitch to my fixture directly, but it won’t recognize it while it does recognize Resolume, so thought I could get this to work.
Any suggestions would be appreciated, or if there is a better idea altogether I'm open to hearing about it.
Thank you!