Hi there,
I am noticing softness in the output from Resolume. I have attached a photo of a 1m x 1m 2.6mm LED screen the left half is a direct feed from a Barco S3 into 1 LED Processor, the right side is from Resolume into a second LED Processor capturing the same MSI laptop source via Blackmagic Decklink Quad SDI Capture. I have also tried the grid image as a direct source in resolume rather than the capture but still soft. If I close resolume and put the same grid image as desktop background this is as sharp as the left side. I have swapped, tested and ruled out all hardware being the problem!
I cannot find any setting within Resolume that might improve this.
Has anyone else had this "problem" or does anyone have a fix for this??
Cheers