Resolume Forum

when adding content during playback. if i drag content into the clips area all of my video outputs including control flash. I never had this issue with previous versions. It doesn't result in a system lockup or anything terrible just a blank frame. anyone else have this issue?
thanks!

viewtopic.php?f=12&t=9167

Specially please, read this...

- Only if you can't find your problem on the forum, create a new topic. When creating a new topic, please provide the necessary info on your hardware and software setup (operating system, graphic card, Resolume version, codec and filetypes used).

windows 7
Arena 4.1.4
3.5ghz dual core
16gig dual channel ram
7200rpm drive(programs/os)
120gig SSD(content)
HD7770 GPU

control monitor is hdmi>dvi
Main one is DVI
Main two is mini DP>DVI

sometimes i convert and run analog signal, but mostly all digital anymore.

during playback, all outputs including control will flash for one or two frames when i attempt to add more content into the clips section. everything is A-OK if i do not add ADDITIONAL content during playback, but even dropping a small JPEG is causing issues, I did not have this issue in previous versions....

I've having the same issue on a gig this. Only happens when I try to add a clip.
Todays setup
i7
16 GB Ram
hd7970
triplehead2go Digital Edition
7 projectors
1 control monitor
Composition 2560x1920

Is it possible for either one of you to record this happening?

Sorry. Too late for me. I've already finished the gig. One day fashion show type of thing. I did noticed this only happened on old stock clip I used. They were DXV but I had converted then maybe 2 years ago. I had to drop in a DXV clip that was 2560x1600 during show and everything was smooth.

The only other factor I can think of is I did power down between flashing and not flashing.

If it wasn't for this I wouldn't have though twice about it as I was pushing the limit outputs, 8 with a triplehead2go expanding my hd7970.