Page 1 of 1

Projector Projection Area

Posted: Fri Nov 29, 2013 04:21
by pfelberg
This usually happen to me:
Lets say I am runnig a full hd projector.
My mac second display output is matching projector' s resolution.
Projector is positioned so the blue menu display screen is bigger than the mapping surface, so it is just a matter of closing edges in.
But when the mac is connected, mac o.s. second display, which is matching the projector's resolution, is already projecting an image smaller than the projector full capability — the blue screen.
why is that? what am I missing?
tks

Re: Projector Projection Area

Posted: Fri Nov 29, 2013 08:19
by gabonacorp
what macintosh maschine are you useing?

if you are in a non-retina macbook pro, or air, and if you connect the projector your displays are mirrored, than the projector gets the normal display resolution, for example a 2010 mid 13' macbook pro in mirrored mode gives 1280x800px.

just an idea.

Re: Projector Projection Area

Posted: Fri Nov 29, 2013 16:22
by pfelberg
This is not it.
It is not a retina model indeed. Mine is from 2011 I guess.
But it is not mirrowed anyway.

That reminds me some overscan feature on PC that there isn´t such thing on the mac I could find so far.

Re: Projector Projection Area

Posted: Sat Nov 30, 2013 02:01
by LXConcepts
are you sure the projectors resolution doesn't change when you send it signal? The blue screen (typically 'no signal) isn't always the same size as what you've set it's resolution to be

Re: Projector Projection Area

Posted: Sat Nov 30, 2013 03:47
by deepvisual
this can happen for a variety of reasons, depending on the make of projector, which you dont mention.

a factory reset is a good place to start as you may be using previous size settings.
many projectors will use an 'actual size' set up for input signals which is often less than the projector raster
ie you send 1920x1080, but the projector is actually 1920x1200
you can stretch your signal to fit in the menu - usually there is a fit/fill screen option.

Re: Projector Projection Area

Posted: Sat Nov 30, 2013 15:00
by pfelberg
LXConcepts wrote:are you sure the projectors resolution doesn't change when you send it signal? The blue screen (typically 'no signal) isn't always the same size as what you've set it's resolution to be
Doesn´t seem to change its resolution. I´ll keep an eye on that.

Re: Projector Projection Area

Posted: Sat Nov 30, 2013 15:01
by pfelberg
deepvisual wrote:this can happen for a variety of reasons, depending on the make of projector, which you dont mention.

a factory reset is a good place to start as you may be using previous size settings.
many projectors will use an 'actual size' set up for input signals which is often less than the projector raster
ie you send 1920x1080, but the projector is actually 1920x1200
you can stretch your signal to fit in the menu - usually there is a fit/fill screen option.
Will check this out. Thank you guys.

Re: Projector Projection Area

Posted: Thu Dec 05, 2013 00:13
by disconappete
factory reset, then focus your projo with an internal grid/pattern(this will show your the full raster of the projo, then send it a grid from your resolume machine, I load one in and "scale to fit comp. alternatively, use the resolume test card since it is scaled. lastly, if the factory reset did not work check your scaling on the projo, this should have been reset on factory reset.