So, here's my issue- setting up a museum install of two projectors
with tons of warping and a blend.
Great forever, but now... it's fine in the advanced output
window and running in Resolume 5.04... however...
...Once I RESTART to run in advanced output automatically,
there's a sharp edge on the blend. UNTIL I click on OUTPUT/ADVANCED/
in the menu. Then it goes back to looking great again (see image)
What the heck IS this? I can't actually FIX it because, of course, it's
only there when I'm NOT in the advanced output window. But it comes
back every restart.
?????????????