Resolume 6, DMX, Artnet and Strip Controller

Post your questions here and we'll all try to help.
Post Reply
Rob Proscreens
Met Resolume in a bar the other day
Posts: 4
Joined: Mon Apr 30, 2018 10:13

Resolume 6, DMX, Artnet and Strip Controller

Post by Rob Proscreens »

Hi, any advice appreciated on Artnet. (Resolume 6)

Trying to connect to an Artnet Led Strip controller. Controller says it is connected. Either via. broadcast or Controller ID and IP.

Resolume's and other Artnetometers all showing Resolume outputting DMX correctly. Artnetometer nodes showing controller.

DMX work shop showing all nodes. No activity indicated on Controller nodes.

Controller works with Madrix. (My client does not want to go anywhere near Madrix ;)

My question's are:

Is Madrix a different Artnet protocol?
Which version of Artnet does Resolume 6 use?
Is this version backwards compatible?
Has anyone encountered similar and found a solution?

Regards and TIA,

Rob Vary.

Zoltán
Team Resolume
Posts: 7088
Joined: Thu Jan 09, 2014 13:08
Location: Székesfehérvár, Hungary

Re: Resolume 6, DMX, Artnet and Strip Controller

Post by Zoltán »

Are you outputting to the correct universe:subnet?
Resolume numbers them form 0 (which is the first one), your strip controller might number starting from 1.
Software developer, Sound Engineer,
Control Your show with ”Enter” - multiple Resolume servers at once - SMPTE/MTC column launch
try for free: http://programs.palffyzoltan.hu

Rob Proscreens
Met Resolume in a bar the other day
Posts: 4
Joined: Mon Apr 30, 2018 10:13

Re: Resolume 6, DMX, Artnet and Strip Controller

Post by Rob Proscreens »

Yes, and just to test I have run outputs to different subnets and universes in sequential order.

Zoltán
Team Resolume
Posts: 7088
Joined: Thu Jan 09, 2014 13:08
Location: Székesfehérvár, Hungary

Re: Resolume 6, DMX, Artnet and Strip Controller

Post by Zoltán »

Do you have both Resolume and your led controller on the same IP address range?
Software developer, Sound Engineer,
Control Your show with ”Enter” - multiple Resolume servers at once - SMPTE/MTC column launch
try for free: http://programs.palffyzoltan.hu

Menno
Team Resolume
Posts: 137
Joined: Tue Mar 12, 2013 13:56

Re: Resolume 6, DMX, Artnet and Strip Controller

Post by Menno »

Does resolume correctly detect the nodes as well? They should show up in your right click menu on the lumiverse in the screen setup. If they dont show up you might need to change network adapters in the preferences.

Post Reply