Hi, any advice appreciated on Artnet. (Resolume 6)
Trying to connect to an Artnet Led Strip controller. Controller says it is connected. Either via. broadcast or Controller ID and IP.
Resolume's and other Artnetometers all showing Resolume outputting DMX correctly. Artnetometer nodes showing controller.
DMX work shop showing all nodes. No activity indicated on Controller nodes.
Controller works with Madrix. (My client does not want to go anywhere near Madrix
My question's are:
Is Madrix a different Artnet protocol?
Which version of Artnet does Resolume 6 use?
Is this version backwards compatible?
Has anyone encountered similar and found a solution?
Regards and TIA,
Rob Vary.