Resolume Forum

Hello everyone i know this isnt a resolume issue but i hope you can help. I recently got a some Microh screens to perform with and when put them up some of the tiles are brighter than some. These are all from the same batch bought at the same time. Is this an issue that can be overcome by software wether it be novastar or can i use resolume to make the outliers look like the rest or some other fix? Thanks alot.

LEd Contorler / led Panel setup are the place to play

If you’re running novastar you should be able to pull the receiver card info from a “good” panel and send it to all of the others. This usually sorts out brightness issues.

He2neg wrote: ↑Wed Feb 27, 2019 12:54 LEd Contorler / led Panel setup are the place to play

Thanks for the advice.

Empyfree wrote: ↑Wed Feb 27, 2019 13:41 If you’re running novastar you should be able to pull the receiver card info from a “good” panel and send it to all of the others. This usually sorts out brightness issues.

I will definitely try this I have used it to solve other issues in the past so its worth a try. Thanks for the advice

Empyfree wrote: ↑Wed Feb 27, 2019 13:41 If you’re running novastar you should be able to pull the receiver card info from a “good” panel and send it to all of the others. This usually sorts out brightness issues.

That will fix brightness, but not color. But always a great place to start

Depending on what model of receiving cards you have, can you take your processors brightness to 100, then down to 0, then back to 100? That will fix a lot of issues as well depending on your make/model of receiving card.