I'd like to record 4 minutes video and audio, 1080x1920 with 30 fps. I tried three times now, every time Resolume stopped recording after 30 to 54 seconds. The resulting file after 54 seconds was 126 MB. I think still have 20,6 GB of free RAM.
Why does Resolume stop the recording? The manual says:
" If recording suddenly stops, this is because you have run out of memory. When recording,
Resolume tries to write the rendered frame immediately. This is done at a very low priority,
because you don't want this to interfere with the actual output. So when it's too busy (lots of
effects/clips/pixels), it stores the rendered frame in memory, and tries to write it later. At a certain
point, when the memory is 90% full, it will stop recording and write the remaining frames in
Which memory is meant here, when 126 MB is 90%?!?
4th try: the recording stopped when RAM was at 41%. I could not do the screenshot fast enough, so it shows 36% here: