Hello,
perhaps theres a Workaround/Solution for my Problem:
Setup:
I generate a trigger from Touchdesigner for "Next Column" to play all Columns as an endless Loop. (Workaround for the missing "Column Autopilot"). Its for a permanent Installation. Resolume and Touchdesigner starts automatically when PC is switched on. Everything is working fine.
Problem:
Resolume generates everytime the composition is loaded an empty column at the end. So after the last programmed column i always play an emtpy column. After deleting it manually everything works fine. But it´s not possible to delete this empty column everytime the system starts automatically. Number of Columns are changing, so it´s not possible to trigger the programmed Columns directly by number.........
Any Suggestions ?
Greets
Maze