When i try to open the flash engine of iwall in resolume, resolume crashes. Any other flashs are playing fine, so might be the problem of the iwall flash engine. FFGL Plugin / Source should be better for use in resolume.
1) I was able to make iwall 3.2 to work on Parallels. It is even possíble to (COMMAND + TAB) alternate outputs between Avenue and iWall flash engine while they run simultaneouslly. But that´s a fact iWall shall never run on Mac OS.
2) I could also capture iWall flash output from the PC to the MAC, using a EasyCap 60+. The go to sources selection on mac´s Avenue and just select it. You can then just drop iWall output on any layer. Course, this is analog composite video signal being captured, which is crappy enough.
3) I may now work on the crazyest solution of all. Install Avenue and iWall, both on Parallels. I don´t know what´s the deal then... why don´t just run both directly on a PC? Well, the fact is that my PC video card cannot support Avenue and I desperately need they talking to eah other.
I just tried droping iWall Flash Engine from Parallels to an Avenue layer on a Mac.
- Avenue haven´t crashed at any time;
- An iWall Logo appeard in the output preview, then an error message: Network Connection failed. TCP connection to port 49255.
I disabled both Firewalls (parallels and mac) but no success so far.
