Resolume Forum

Hi

Im new here so if you meed any more info just ask.

Im using Mapio to map a cube but my output shows both the Mapio output and the resolume output.

For example Mapios output shows over the top of the selected sample.

Can anyone help to just show the Mapio output in the main output

Thanks

where have you loaded mapio?

I thought this was where I was going wrong. I've been adding it like a clip as I wanted the ability to easily switch between different maps.

Where should it be placed? I've tried it in the effects of the layer but edit mode wont open when I put it here.

Thanks

if you add it like that, then the mapping is only applied to that clip.

adding it on a layer will affect any clips played on that layer and adding on the composition effects every clip.