Resolume Forum

Thank you...shamanicape

Hey,
i tested it now as well and say its nice to work with.

I had the wish to have the Option to Tab the BPM on the Pad as well and so i added 1 Pad into the Template.

I created a "pad" inside Lemur and then just try to map it to the Tap button.
I thought i´m smart and just copy all the values from your resync pad and just change the adress. But it dont work.
LemurPad: OSC 0 // Trigger: Any Changes // Midi: disabled // Note On: Pitch 0/Channel1 / Trigger: Any Changes
Custom Adress : "/playbaclcontroller/tab"
What did i missed here... ?! Dont think it can be much...


EDIT:
Ring the Bell and call Shame.... i missspelled tab =/=tap
everything working....

Information :

I run into an issue and solved it

Problem : Ip & Port is set correct but the Signal is not coming through

Solution : The IP was 192.168."2".XXX and have to be 192.168."1".XXX



So i dont know if its for all OSC / Midi & Lemur Apps but it dont work when the IP is xxx.xxx.2.xxx

It may will help some1

Hi Cosmowe.

I downloaded the files you had in the first post and cant seem to get the vfx bank to load into Resolume as you have in your demo.
Im running Resolume 5.0 and Lemur 5.3.2.

I also dont seem to have the sequencer buttons on the ipad interface.. Just small grey bars.

Any ideas?

Thanks

Hi Happymanners,
I've tested it right now. Seems to work for me.

- Which iPad do you use?
- May you show me a photo of your sequencer bars?
- Did you used the Demo *.AVE file for testing?

best wishes
cosmowe

Hi Cosmowe.


AS per your q's

Im running an Ipad Pro

Im running Resolume 5 and the pics are as attached.

I used the files as per your original post

If you need more info let me know......

Thanks

Matt

Seems that you ran into an iPad pro incompatibility. I would recommend you to place an email with your screenshots and your problem HERE!!!
The grey bars you see on your ipad pro are decorative elements I added underneath the sequencer buttons to make them visually separated in 4/4 bars. So it seems that the whole sequencer module is not able to be loaded at all.

Do you have an typical iPad to make a reverse test?


So.. you also wrote that you don't have the video fx inside Resolume which I pre added in the demo *.AVE
You will see them when you extend the [Video Effect] Tab in Layer 2&3.


Greetings
cosmowe

Hey Cosmowe

Thanks for the info.. Ill give the reverse test a go in the am, but yeah Incompatibility was one of my 1st thoughts too.

I see the effects now yay.. Thanks for that point. I was expecting them to be on the master out....

Ill flick liine an email too..

Thanks for the help.

Matt

nice...keep us informed when you get an answer from them.

Best wishes
cosmowe

Hey.

Ive put your module into my ipad3 and still same issue. Thought the iPad pro may of been issue but no.
The screen is the exact same as the screen shot I put on the thread from my iPad pro.


Meh!!!

Any ideas?