So I've been playing with the audio FFT and have made some cool progress with it, definitely lots of ideas of how to start patching it.
However I built an effect and could not get it working. The goal is to drive a limited frequency band from audio FFT to trigger a midi command for momentary selection of the random clip playback mode for a layer.
The basic patch is as follows:
Audio FFT ->
Linear (8 Instances) ~ Read ->
Split ->
(at this point we have 8 frequency bands distributed across the incoming audio spectrum)
Int In ~ Switch->
Greater Than ->
(now we should be able to select between frequency bands and have a minimum threshold for a true value)
A this point we can drive the true value to any destination. Where I'm lost is creating Midi data for a momentary button press, which will temporarily trigger the random clip playback mode. I created the patch as an effect and played with many of the Midi write nodes but could only get the Midi trigger to permanently activate random clip playback mode.
If anyone can help with the structure of the patch that would be amazing.