Page 1 of 1

changing default playback mode?

Posted: Tue Jan 04, 2005 00:16
by r.ke
is there a way to change default settings for the playback mode in resolume 2? I'd to play the clips in start over and bounce mode by default without changing the settings each time.

Posted: Tue Jan 04, 2005 14:30
by bart
it is not possible to set the default mode but you can change all the channels at once by holding down SHIFT and then setting the desired playmode

Posted: Wed Jan 05, 2005 23:50
by Ruud
:D

good one ;)

I like it!

greetz /ruud

Posted: Thu Jan 06, 2005 11:11
by bart
note that you can do this with a lot of buttons in resolume ;-)

Posted: Fri Jan 07, 2005 03:45
by r.ke
Originally posted by bart
it is not possible to set the default mode but you can change all the channels at once by holding down SHIFT and then setting the desired playmode
Thanks, sounds nice. :)

Posted: Wed Jan 19, 2005 13:57
by Ruud
are there other super-handy shortcuts not mentioned in the Resolume manual?

I'd like to know them!

Posted: Wed Jan 19, 2005 19:04
by Sense
CTRL-ALT-I (Resolume prosessing information) Quite hendy for testing.

Posted: Wed Jan 19, 2005 21:28
by VJair
nice tip Sense :cool:

Posted: Thu Jan 20, 2005 11:05
by edwin
Shortcuts:
Holding down SHIFT whilst settings layer settings will set that setting for all layers.
Holding down SHIFT whilst settings channel settings will set that setting for all channels.
CTRl+ALT+ENTER will bring up the screen setup window, this however stops the current output. so we use it mostly when we can't get to the screen-setup button with the mouse (when you have a single screen setup and your output is fullscreen).

all other shortcuts are listed in the preferences.

other tricks.
when right-clicking an effect parameter slider it will reset that slider to it's original setting. This also works on the sliders in the audio section.

cheers
edwin

fanrastic

Posted: Thu Jan 20, 2005 13:52
by pifco
Cheers edwin