Possible to preview the A/B crossfader buses?

Just let it all out, buddy. You're among friends here.
Post Reply
User avatar
gpvillamil
Is seriously in love with Resolume. Met the parents and everything
Posts: 484
Joined: Mon Apr 04, 2005 03:33
Location: San Francisco, California

Possible to preview the A/B crossfader buses?

Post by gpvillamil » Tue Dec 04, 2018 01:11

Started poking around with using the Crossfader. I haven't used it in the past, but started working with someone who likes setting up stacks of clips on the A & B buses, and then mixing between them.

My question is: is it possible to preview the A and B buses without showing them on the main output? Ideally I'd like to be playing the output of bus A, then set up a stack of clips on bus B, in the preview window, prior to fading it in.

Joris
Doesn't Know Jack about VJ'ing or Software Development and Mostly Just Gets Coffee for Everyone
Posts: 5060
Joined: Fri May 22, 2009 11:38

Re: Possible to preview the A/B crossfader buses?

Post by Joris » Sat Dec 08, 2018 12:37

This is not currently possible.

You can get pretty much the same behavior by using groups to set up your stacks. Then you can either assign the groups to the crossfader or just mix between them regularly.

User avatar
gpvillamil
Is seriously in love with Resolume. Met the parents and everything
Posts: 484
Joined: Mon Apr 04, 2005 03:33
Location: San Francisco, California

Re: Possible to preview the A/B crossfader buses?

Post by gpvillamil » Mon Dec 10, 2018 21:46

Ah cool, then you can preview the groups?

Post Reply