I have a strange issue with the main comp I use. I can't reproduce this in a blank comp. I'm using R6 demo / no license yet since I'm trying it out before upgrading.
This issue does not happen on Resolume 5
When I map a clip to any of the MPD232's drum pads. And use the MPD232's internal clock to drive resolumes BPM. If I select a column or new clips then hit the drum pad for the clip I assigned it to the BPM hits 20 then shoots up to 500, then sticks for 2 seconds and then goes back to the normal BPM the midi controller is sending.
I've double checked the controller and again tried this in a fresh comp in R6 and it doesn't happen. I've combed through my main comp I'm working on and the note the drum pad is sending is mapped only to that single clip.
It seems to really hate it when I assign a drum pad to a clip with any bmp sync. It behaves a bit better when there is no bmp sync but I have seen it happen at times. Is there some new setting between R6 and R5 that causes this?
I've not noticed any irregularity in the tempo flash on the MPD232 so it appears to be sending a steady clock. It's only when it gets to resolume is goes nuts when I use a drum pad mapped to a clip. BTW all other features I've mapped the drum pads to in R6 work fine. It's only clips that seem to cripple the BPM.
The Midi controller preferences in R6 is set to
Midi input
Midi output
Clock input