Resolume Forum

Hey all! I hope someone can help me.

I have just started with projection and last weekend I did a projection for a local concert. The stage had a different screen with different shapes.

So I went to ADVANCE MODE and did a very simple mapping in order to see correctly my clips.
Did the testing and I noticed that when I´m in advance mode the software won´t respond good.
With this I mean that if I wanted to change clips, go black, lower opacity or animate live my clips get stuck and stop playing correctly..

If I project on normal MODE everything works fine, but in this concert case I needed to do simple mapping.

Any idea?

Hope I made myself understand lol

Thanks you!

It sounds like you are using a graphic card that does not pack enough punch to run the Advanced Output.

What does the log report as the main OpenGL Renderer?

You can access the log by going into Resolume > Feedback > View Log and then scroll down to the part where it says 'Main OpenGL Renderer'

There's some screenshots on what to look for in this thread.

Thanks Joris for your reply!

I thought the same but I am using a 2013 Macbook pro so it should not give car issue (I use it for 3D modelling too!) i guess... I have use some others mac book with no problems at all.

Still. I will send you my log report as soon as I get home so you can give a major idea of what is happening!

Thanks!