Resolume Forum

Hi there!

I´ve been testing 4.2.1 for two days and i am very pleased with it in combination with our ETC Congo JR with Cobalt installed.
The Laptop and the Lightdesk are connected via Artnet. Mastersection works great and the first three Layers work great too.
But the Layers 4,(4+n),... won't do a thing. I am sending Artnet-information out of the desk.

So to my Question: Is this a Demo limitation?

Thanks for any answers!

CU
Jens

The demo is fully functional and identical to the registered version aside from the visual and audio watermarking.

I just did a quick test running Luminair on the iPad, and layers 4 and up work as expected. Forgive me if this is a stupid question, but have you actually added a fourth layer in Resolume?

Thanx for the quick answer!

I was experimenting layers to slices. I made 8 layers. I´ll check it again tomorrow and give an update.

CU



Usually it´s a user error ;0)