Having a networking issue between Arena 6.1.3 and our Unison House Light Controller.
Recently upgraded our Resolume computer. Everything worked fine with the old computer. Using same composition, advanced output, and everything from that old computer.
MA2 OnPC 22.214.171.124 on MA computer
Resolume Arena 6.1.3 on Resolume computer
58 Artnet Universes of LED tape, sending Artnet from both Arena 6 and MA2
8 Elation eNode8 Pro for LED tape DMX output
1 Elation eNode4 for Lighting Fixture DMX output
Unison House Light Controller
2 ETC Sensor+ Dimmer Racks
Issue seems to be a network collision from Arena. I'm able to control house lights from either MA2 or the house light controllers in the building up until I start Arena 6. Once Arena starts, I lose the ability to use the house light controller. I'm still able to control the dimmers from MA2. If I close out of Arena within a few minutes, I instantly regain control with the house light controller. If I leave Arena on for a bit, I have to restart the entire house light controller system to get control back from house light controller.
All 58 Artnet outputs from Resolume are set to target IP using Advanced Output, nothing is broadcast from Resolume. MA2 has 1 Artnet universe that is broadcast to all the LED tape, just to do basic color for easy control. MA2 is sending 1 Artnet universe to Resolume for control of Resolume.
I've looked at all the IP addresses and nothing is conflicting.
Is there something that Resolume is broadcasting behind the scenes that would cause an issue? Any help is much appreciated