Page 1 of 1

Undocumented OSC commands? Looking for BPM resync.

Posted: Wed Aug 29, 2018 23:24
by gpvillamil
I am in the process of updating some of my good old Max patches (sequencer, chaos mode) to support Resolume 6. I know AutoPilot now does most of that, but hey, sentimental.

I've been able to easily update clip triggers and BPM setting, but I am missing the Resolume 6 equivalent of

/playbackcontroller/resync/ 1

That would resync the BPM counter to the beginning of a 4 beat bar. Can you tell me what the equivalent is for Resolume 6?

On another note, I love the polling feature. I remember asking for that a long time ago, glad it is there!

Re: Undocumented OSC commands? Looking for BPM resync.

Posted: Thu Aug 30, 2018 21:30
by gpvillamil
Also:
I don't know if these are good examples or not. You're supposed to be the creative mind here. I never get to do anything cool with OSC anymore because I'm stuck in an office writing a manual that no-one reads.
I read the manual!

Re: Undocumented OSC commands? Looking for BPM resync.

Posted: Thu Aug 30, 2018 21:38
by Zoltán
gpvillamil wrote:
Thu Aug 30, 2018 21:30
I read the manual!
You sure? ;)
So how do you figure out what the address is for a particular control? Although there is a certain
logic to it, it's easiest to just enter OSC Shortcut mode (Shortcuts > Edit OSC), and click the desired
control.
The Shortcuts panel will show you the correct address. You can click the address itself, ready for
copypasta goodness.
https://resolume.com/support/en/osc#osc-addresses

Re: Undocumented OSC commands? Looking for BPM resync.

Posted: Thu Aug 30, 2018 21:44
by gpvillamil
I tried that, but... duh, I'm an idiot! There it is, all spelled out in uppercase RESYNC!

Thank you for your help, and your patience!
Zoltán wrote:
Thu Aug 30, 2018 21:38
gpvillamil wrote:
Thu Aug 30, 2018 21:30
I read the manual!
You sure? ;)
So how do you figure out what the address is for a particular control? Although there is a certain
logic to it, it's easiest to just enter OSC Shortcut mode (Shortcuts > Edit OSC), and click the desired
control.
The Shortcuts panel will show you the correct address. You can click the address itself, ready for
copypasta goodness.
https://resolume.com/support/en/osc#osc-addresses