Resolume Forum

joshuadmello wrote:
Yep.

With V-Sync on + Fall creators update + 385.69 Drivers I'm getting a solid 60FPS constant. No screen tearing on strobes.

Even with 2 outputs through USB C to DP 60 FPS.

hey I'm still having the same fps issues with the new update and driver [385.69]. it hovers around 30 fps and drops to 15 for a bit then back to 30

this doesnt look right does it? its an 8gb card. is memory leaking?

After installing resolume 6 and new nvidia driver (gtx 970m) on my old laptop running windows 8.1. My old laptop has V-sync off and runs so smooth over 100fps (sadly only has 2 outputs though).

I’ve narrowed it down to a few issues why I can’t remove screen tearing.

1. Windows 10 is garbage
2. Nvidia Max Q cards
3. Haven’t found the right driver

Please help!

UPDATE

I did a clean driver install and after installing nvidia driver 385.69. I'm able to get 60 fps with the setting "use 3D application setting" not V-sync on, not V-sync off.

I just don't understand why on my old system I can get well over 100 fps using a 970m on windows 8.1, but on this system with a 1070 Max Q on windows 10 it I cant get above 60??

I'm going to try other drivers and see if they work better

Yea man that is very strange.

Ill do some more tests on my Razer. It has the GTX 1060.

Ill keep you posted.

rawdesigns wrote:UPDATE

I did a clean driver install and after installing nvidia driver 385.69. I'm able to get 60 fps with the setting "use 3D application setting" not V-sync on, not V-sync off.

I just don't understand why on my old system I can get well over 100 fps using a 970m on windows 8.1, but on this system with a 1070 Max Q on windows 10 it I cant get above 60??

I'm going to try other drivers and see if they work better

Have you tried outputting yet though? I get the same results until I begin outputting, even just to one 1080 display via HDMI.