Resolume Forum

Hi!
Is there a way to switch the Output Preset Fast?
Would be great to switch it over Artnet.

advanced output presets can't be changed remotely.

what are you trying to accomplish?
maybe it can be done an other way.

I have a LED Screen consisting of 5 pieces.
Sometimes all 5 Elements should be one big screen and sometimes i want every element show the same hole Picture.

there are a few ways you could do this without having to switch output presets.
one way would be:
so assuming you have your 5 piece led screen set up horizontally,
creating a screen with its output set to virtual,
then create 5 further slices so you have 6,
the most bottom one's input should be composition, the other slices set to layer 3.
now resize the 5 top slices to occupy a different 1/5 th of the output you have each.
save'n close
place a layer router in layer 3 set input: layers below, this will be your switch to have the 5 LEDs the same content each.

now by launching the layer router clip or anything playing in layer 3 will be shown in the 5 LEDs the same way, and if layer 3 is empty then the 5 fixtures will act as one big display