Resolume Forum

Hello,

Led feedback (with APC mini Mk1, maybe other controllers too) doesn't work fine since v7.24.0.
Is it fixed in v7.24.1 please?

Some button doesn't light up randomly.

Thank you

can you share some screenshots, of the midi preferences, and the shortcut setup?

Hi Zoltan,

Here are the screenshots.

I don't know, if you need more but I will try to explain what's happened.
Everything worked perfectly until v7.24.0.
Then I've seen that some leds don't react until I press the button. And when I change deck and go back, the problems happen again. I've tried different cables, started a new fresh midi preset but It didn't change anything. So I decided to go back to v7.23.2 and the problem was solved.

Thank you

Thanks, we were able to recreate the issue, and are looking into a fix.

Thank you !

I was going to post a similar issue with OSC messages re clip state only sometimes being sent when changing Decks in the current version. Rolling back to 7.32.2 seems to have fixed that.

However, and this may be a bit of an edge case, but I wanted to ask:

In 7.23.2, (and the latest build) - doesn't matter the actual position the clip:

If a clip at Deck 1, Layer 1, Clip 1 is left playing when you switch to Deck 2 and there isn't a clip in that spot in Deck 2 the clip state of that position doesn't update to empty. If there is a clip there in Deck 2, it does update to present, not connected.

And vice versa, if you still have that clip from Deck 1, Layer 1, Clip 1 playing while in Deck 2 and switch back to Deck 1 the clipstate of the playing clip doesn't update to show the clip is playing even though the clip border is highlighted to show it is.

Easily fixed by just not leaving anything running when changing deck obviously, and that's what I'd usually do but still. seems wrong.

Thanks, sounds like the same issue about shortcut handling.

Yeah, I didn't think opening a new thread was appropriate as it seemed to be the same thing but just with a different protocol.