Resolume Forum

Hi, I don't think it is the processor.
The exact edid resolution of the LED screen is set on the processor and the graphics card.
There would be no black border.

I will look at the server tomorrow and upload the crash report.

Thanks

This happened before when we had a straight hdmi cable from pc to processor so I know it's not that.

Where do I find the crash report?

Could you describe your setup, and how you send the outputs?

Were you able to send us the crash report with the reporter dialog ?


Hi, thanks for the reply.
Hardware as described in the first post.
We then send video over Cat5 using a Hall research hdmi over Cat5 transmitter and receiver kit ...

Anybody???

Hi, we had an issue recently where our main output, once activated, would shift to the right, approximately 50cm on a 10 metre LED screen.
Nothing we did would rectify this and eventually resolume would crash.
We had this problem previously and matching all refresh rates on graphics card, input ...

I have four outputs, 3 hdmi and 1 display port.
Display port is used for my preview monitor which shows minimal latency in the preview window, and a hdmi direct to an LG television for testing.
We normally use this to run an LED screen with a video camera plugged into the vision sc-sdi4 capture card ...

Hi, in an attempt to resurrect this post, I also have a latency issue.
Core i9
Datapath vision sc sdi-4 capture card.
32 gb ram
Estimated 250ms delay.

Any ideas?