DJM-900NXS2 mixing table outputs

Bro, does your rig even lift?
Post Reply
sefreso
Is taking Resolume on a second date
Posts: 32
Joined: Thu Nov 07, 2019 21:36

DJM-900NXS2 mixing table outputs

Post by sefreso » Fri Dec 27, 2019 11:54

Hello,

Can someone tell me which output of the DJM-900NXS2 mixing table is best to use so that I can use the external FFT in resolume?

Here is a good picture of its back sockets : 
Image

And here is the documentation : http://docs.pioneerdj.com/Manuals/DJM_9 ... al/?page=2

I am wondering whether it's better to use the RETURN outputs or MASTER 2 or REC ?

I am using a Focusrite 4i4.

Thanks in advance!

t13swift
Hasn't felt like this about software in a long time
Posts: 152
Joined: Thu Mar 26, 2015 14:00

Re: DJM-900NXS2 mixing table outputs

Post by t13swift » Fri Dec 27, 2019 15:14

For RCA you could use either Master 2 or REC depending on if you wanted the mixer master volume control to affect the fft.

The RETURN is an input into the mixer.
The Master 2 audio is the same as the Master 1 XLR outputs.
The REC output is the Master audio but pre the master volume knob + limiter.

Hope this helps!

sefreso
Is taking Resolume on a second date
Posts: 32
Joined: Thu Nov 07, 2019 21:36

Re: DJM-900NXS2 mixing table outputs

Post by sefreso » Fri Dec 27, 2019 15:18

I meant SEND instead of RETURN.

Could the SEND be used in case I only have XLR cables?

Thanks. This helps a lot!

t13swift
Hasn't felt like this about software in a long time
Posts: 152
Joined: Thu Mar 26, 2015 14:00

Re: DJM-900NXS2 mixing table outputs

Post by t13swift » Fri Dec 27, 2019 15:35

sefreso wrote:
Fri Dec 27, 2019 15:18
Could the SEND be used in case I only have XLR cables?
I dont think so.
It would only output the input channels sent to the send/return effect and I thought that the mixer also needs the return connected to not break the path for that channels effects.

User avatar
He2neg
Wants to marry Resolume, and Resolume said "yes!"
Posts: 645
Joined: Fri Nov 22, 2013 21:34
Location: Berlin, Germany

Re: DJM-900NXS2 mixing table outputs

Post by He2neg » Fri Dec 27, 2019 19:10

Take the Master2 Outputs.... or if possible a seperate signal from the Soundtechnican..

For the problem with cables get 2 cheap DI boxes (passive) and a short rca to 6.3m cable.

its not the best to use long runs of unbalanced signals so the di will be good in any case =)
Laptop: XMG P507 // Intel i7-5500 / GTX-1060 / 1tb SSD / 32gb RAM // Touch OSC / Lemur/ APC-40
~self employed AV technician / Schu.VT@posteo.de~
~Berlin~

Post Reply