changing default playback mode?

[r.ke]

is there a way to change default settings for the playback mode in resolume 2? I'd to play the clips in start over and bounce mode by default without changing the settings each time.

[bart]

it is not possible to set the default mode but you can change all the channels at once by holding down SHIFT and then setting the desired playmode

[Ruud]

good one

I like it!

greetz /ruud

[bart]

note that you can do this with a lot of buttons in resolume

[r.ke]

Originally posted by bart
it is not possible to set the default mode but you can change all the channels at once by holding down SHIFT and then setting the desired playmode

Thanks, sounds nice.

[Ruud]

are there other super-handy shortcuts not mentioned in the Resolume manual?

I'd like to know them!

[Sense]

CTRL-ALT-I (Resolume prosessing information) Quite hendy for testing.

[VJair]

nice tip Sense

[edwin]

Shortcuts:
Holding down SHIFT whilst settings layer settings will set that setting for all layers.
Holding down SHIFT whilst settings channel settings will set that setting for all channels.
CTRl+ALT+ENTER will bring up the screen setup window, this however stops the current output. so we use it mostly when we can't get to the screen-setup button with the mouse (when you have a single screen setup and your output is fullscreen).

all other shortcuts are listed in the preferences.

other tricks.
when right-clicking an effect parameter slider it will reset that slider to it's original setting. This also works on the sliders in the audio section.

cheers
edwin

[pifco]

Cheers edwin