Midi Cues for clearing content not properly working

[tyler]

The midi cues I have used to clear content is not working properly. It seems to not use the cue to clear a layer that has content on it, which is the whole point. It does however show the activation on layers with no content. This is the same system I always use, it has always worked before, and has not been unplugged. Looking for help or ideas. Did something change I need to fix, or is it a software malfunction?
Ex. I have a column selected with multiply layers in use, I have midi cues triggering out of the song to clear everything but the one layer I need, and it selects a video, and the video plays seamlessly. Now, the video is selected, yet the motion graphics are still coming through an not clearing according to the cue, and it looks like bad. I even reset the midi cues, tripled check them, and made new cues all together. Nothing is working.

[Zoltán]

If layer transition time is enabled, then it would take a few seconds for layers to clear.
https://resolume.com/support/en/layers#layer-transition

Layer content can also be locked.

[tyler]

If layer transition time is enabled, then it would take a few seconds for layers to clear.
https://resolume.com/support/en/layers#layer-transition

Layer content can also be locked.

Nope, none of this. Doubled checked. It's weird, because i can physically watch the blue selection go in and out when there is no content on the layer, signifying the cue is triggered, but with content it does nothing.

[Zoltán]

Could you make a screen recording?
Would be interesting to see what you see.