Totally new to Resolume. Go easy on me.
I'm looking to control Resolume in a workflow that is very similar to Catalyst/Mbox/Hippo where the vast majority of programming is done at the lighting console. I've already figured out how to map common parameters (dimmer/scale/position, etc) to ArtNet channels. The stumbling block right now is trying to figure out how to load clips arbitrarily from ArtNet with two channels (folder/file) the same way those other servers behave.
The closest shortcut I've found is "connectspecificclip" but that seems to just allow me to pick from a selection of clips aleady [manually] populated onto a layer.
Is there a way to configure Resolume to assign a clip to a layer on the fly the same way Catalyst/Mbox/Hippo does it via ArtNet?
I snooped the forum quite a bit for tips on doing just this but couldn't find a winning solution. This is one thing preventing me from adopting Resolume into my workflow.