I have some unusual trouble with the Enttec DMX Pro and Resolume 3.3.1.
DMX in on my MacBook under OSX10.5.8 - Fine
DMX in on my MacBook under Vista 32Bit - Fine
DMX on WinXP -32Bit - Resolume - Fine
DMX in on my main PC, Win7-64bit - Fine for Light Factory - Doesn't work for Resolume
DMX on same PC, Vista-32Bit - Fine for LightFactory - Doesn't work for Resolume
DMX on different PC - Win7 - 64 Bit - Fine for Light Factory - Doesn't work for Resolume.
Initially I used firmware 1.44 on Both Enttec Out and In. Then after reading about it I found there was some problems with 1.44 when used as an input, (Lag mostly). Changing to 1.43 did not help. I swapped all USB Leads, DMX Leads, Dongles etc. I tried all combinations. In any configuration it works as an input to my MacBook or old WinXP machine.
On Windows 7 - 64Bit I am using the CDM20802 D2xx Direct Drivers as the VCP ones do not work at all for me on Win7 64Bit. http://www.ftdichip.com/Drivers/D2XX.htm
The drivers from the Enttec site http://www.enttec.com/index.php?main_me ... ow=drivers
do not work for me under Win7 64Bit.
I am also using the Direct Drivers under the Vista install on my main PC. It seems Resolume does not like these drivers. Yet using the VCP drivers from FTDICHIP work under WinXP.
I am very keen to get Resolume working on my main PC as it has ATI 5850 with SSD drives etc.
Any help would be greatly appreciated.