Resolume Forum

Same here. As i googled, it seems to be assosiated with intel i9 14900hx cpu.

I use "Active layer" as default Clip Target in composition. Since 7.22, when I click in a clip that is BPM synched, it goes to his own layer, instead of active one. A workaround for this is to set composition's beat snap to "none", but it makes the clips go out of sync.

Some improvements in transform widget would be appreciated for day to day usage. Here, some ideas:

- Ability to finetune move selection with cursor keys, as in advanced output.
- Optional snapping please!
- A way to close preview (as with with right mouse click in previows versions?)
- Enable ...

When I create a monitor to preview an output, it doesn't match displays aspect. Insted, it stetchs to composition aspect.

In reso 7.28, holding shift or ctrl for multiple selection doesnt work. I can select only one slice. Since I have lots of slices, i have to drag them one by one...

Same here. Random black blinking sometimes.
Using resolume 7.15
Windows 11 latest
i7-12700H
RTX 3060
Nvidia studio drivers
Output fullscreen 1920x1080@60. Composition 1920x1080.
It seems to be an incompatibility with Nvidia RTX cards...

@Zoltan, is Arena using HX or is it still full blown NDI? I know a 3G Full NDI stream is about 250mbps where HX is only 25 (also loss in quality)


Ndi HX it is intended for video streaming, because it compress in h264 / h265. Compared with old full-bandwidth NDI, this compression is uses less ...

I had the very same issue. Updated Resolume and nvidia drivers but no luck. The workaround I found is disabling vertical sync in nvidia panel. Since then the freeze moments didnt happen again. I have tearing, but if I limit the composition fps to the output refresh, it becomes less visible.
Asus TUF ...

In my case, I see performance drop when using slice outline... but when i apply beizer masks to slices performance drops DRASTICALLY! It seems it's an explosive combination for my gpu...

I want just that:the way to adjust delay time, flip or mirror, or other parameters that are present in slice transform. That would be very useful!
I tried modifying it in wire, but with no luck.