Dominant IAC Midi Trigger

[Dalien]

Hey guys,
I am working on a setup to playback tracks out of Logic Pro X and sync them with clips out of Resolume Arena 6.
Therefore I am using the IAC Midi Driver inside of Mac OSX (Sierra)

The connection is stable and I can map my setup with different notes without a problem.
The problems occures once I playback the track from Logic.
At that moment Resolume won't let any other control happen. I can't stop the clip, or change it or change anything. By MIDI and by hand in Resolume.

I already tried to set the MIDI Trigger inside of Resolume to Piano. Bust still the same Problem.
I have to stop the MIDI Input in Resolume and restart the program to get it to work again.

Any suggestions?

[Zoltán]

Do you send note offs too?
What does your midi input monitor in preferences show as input?

[Dalien]

No, there is no Off note.
I had a production yesterday where a technician showed me his setup. He just used a "GO" and it worked out fine.
I just checked it in Resolume 5. The Input is not really working properly but you still can control Resolume itself after
getting the MIDI Note run the Clip.

In Resolume 6 the Input works properly. Every Note is showing up fine as it should. But once the clip is triggered it seems like resolume is completly blocking every communication.

[drazkers]

Show us what your sending in the midi monitor.

I still think your sending midi out and creating a loop. :p

[Dalien]

It seem like the problem already occures in Logic.
I am getting the same Monitor with Resolume switched off.

So there has to be a loop inside of Logic already.
Thanks for that. The Monitor was a Tool I did'nt knew before.

[Dalien]

I finally found the solution inside of logic.
Because I still had the MIDI Track in Record Mode he was still receiving the MIDI Notes, that I just send from the same track. So your opinion of a feedback loop was correct. But not inside of Resolume.