NDI Inputs and Outputs
With NDI, you can send video between computers over the network, from Mac to PC and back.
You can even use your phone's camera as a source, with the NDI camera app.
NDI works just like Syphon and Spout, but over the network. So you can send the output of Resolume on one computer to Resolume on another, with nothing more than a regular network connection. No extra hardware needed.
There's no hard limit to how many connections you can set up, but at some point your network will fill up. A 60 fps 1080p NDI stream typically needs at least 150 Mbit/s.
Input
NDI inputs are always enabled in Resolume.
Any application sending NDI shows up in the Sources tab. Add it to a deck like any other live input. Use as many inputs at the same time as your network can handle.

Output

As soon as you enable NDI via the Output menu, Resolume starts broadcasting its main output. Other NDI applications on this computer or on the same network can pick up Resolume's composition output right away.
When sending NDI from the composition, the output has the composition's size. It has the same Pixel Format and Delay settings as NDI screens, described below.
Advanced output

Resolume Arena gives you more control via the Advanced Output, where an NDI output works just like a separate physical screen.
That lets you warp the output before sending it, or send only part of your composition, while your physical screens get something else. You can also set the width and height of the output as you like.
Note: every NDI screen in the Advanced Output is a separate NDI source.
Use Pixel Format to balance quality against bandwidth. Choose 8-bit or 16-bit, with alpha (YUVA) or without (YUV).
- 8-bit YUV is the lightest on your network and fine for most shows.
- Choose a YUVA format when the receiving application needs transparency, for instance to overlay graphics on a camera feed.
- 16-bit gives smoother gradients with less banding, but uses more bandwidth. It only pays off when the receiver works in 16-bit too.
Use Delay to hold the stream back by 0 to 100 ms, so it stays in sync with your displays and capture card outputs.

PTZ - Pan Tilt Zoom
Got an NDI camera that can pan, tilt and zoom? You can control it straight from Resolume.

NDI Gotchas
Network Adapter
NDI doesn't let you choose which network connection it sends on. So when you have both Wi-Fi and a wired connection active, it may well use the Wi-Fi. On a Mac, it always defaults to Wi-Fi when it's available.
As you can imagine, sending video over Wi-Fi is pretty bad. So turn off Wi-Fi while you set up NDI.
The NDI protocol itself can't select an adapter, but the NDI Access Manager can.
Discovery vs Connection
Sometimes an NDI source shows up in the Sources tab, but gets a red Offline mark when you use it as a clip, and shows up as 0x0.
In 99% of cases, that's an IP mismatch. Both computers are on the same network and can "see" each other, but they're not in the same IP range, so the pixels can't be delivered.
The best way to troubleshoot: disable all network adapters except the one you use for NDI. Then give each computer a manual, different IP in the same range, like 192.168.1.100 and 192.168.1.101.
NDI is a professional video-over-IP protocol, and using it means managing your IPs properly. If that sounds hard, that's because it is. IT is a real job, and a completely different ballpark from video, so it can be smart to get help from someone who sets up networks for a living.
Resolving Connection Issues
Some network chipsets have trouble with certain protocol types. Install the NDI Tools on the receiving computer, open NDI Access Manager and, in the Advanced tab, try a different Receive mode.
On a Mac, check Privacy & Security in System Settings, and make sure Resolume is allowed to access the Local Network.
Make sure your firewall lets Resolume communicate.
